Basement Waterproofing; Read the DIY Tips for Your Home Improvement If your basement foundation is poorly constructed, water seepage and condensation may occur when it rains. No one would want to experience such a demoralizing situation, but there is a solution to minimize the condition. Waterproofing is one of the key solutions to reduce this kind of a mess within your basement. Before taking any action, finding a good quality waterproofing product should be your first thing to ponder. This will work well if the block walls are in the right form because preventing water seepage has not been an easy thing. Poorly constructed walls require removal of the loose mortar and broken blocks. Using a wire brush, clean the dirt and grease, plus any other contaminant from the surface. Apply a quick-dry concrete to seal the openings and cracks on the wall. However, it is highly recommended to check the manufacturer’s guidelines before you start patching the cracks. Don’t forget that the mortar should be mixed with the waterproof carefully, putting in mind the extent of moisture seepage. But, avoid the mistake of using inadequate or excessive waterproofing. It’s even wiser to use more of waterproofing because it implies a stronger sealing.
Where To Start with Basements and More
If you apply a thin waterproof, it might not prevent the seeping appropriately. For a higher seeping rate, it is advisable to add another coating. Remember, the waterproof application should be done right at the building material pores. Ensure every crack is properly sealed.
A Beginners Guide To Services
When it comes to buying coating products, it is advisable to shop well for the right thing. If you come across ‘water repellant’ and ‘waterproof coating’, beware that these are two terms used by many manufacturers interchangeably. The two are different things. Water repellant is used for exterior coating above the concrete, and does not really prevent water seepage under hydrostatic pressure. Waterproofing, on the other hand, is often used to prevent moisture leakage under hydrostatic pressure. Waterproofing coating can be applied on exterior and interior walls, on and below the concrete. A heavy downpour flowing towards a house, damaged gutters, wind-driven rain, or high water table can be a cause of hydrostatic pressure. Every homeowner need to distinguish between moisture seepage and condensation. To know the root cause of moisture accumulation on the foundation, place an aluminum foil on the foundation wall and leave it for a few days. If only the foil’s side lying on the wall is wet, water seepage might be the problem. If you notice only the upper side is wet, the problem is condensation. However, if both sides of the foil are wet, condensation and seepage are occurring at the same time. Therefore, a dehumidifier can be used to solve condensation problem while a good quality waterproofing coating can stop the seepage issues.